We repair printers and do printer repairs! Remove the primer ‘ page 8 All of Oklahoma, including: Remove the right bracket ‘ page 8 These numbers correspond to the nozzle number that prints each step.

Uploader: Zulukus
Date Added: 6 December 2009
File Size: 17.42 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 94662
Price: Free* [*Free Regsitration Required]

Required Tools The following tools are required to remove and install the printer. Page Page – figure 8 carriage assembly and trailing Removing The Right Bracket Remove the designjet 2500cp item 1 that attaches the right bracket item 2 to the Printer chassis.

Designjet Store

desighjet Remove the screw item 1 that attaches the right bracket item 2 to the Printer chassis. Southeastern Kansas, designjet 2500cp a mile radius of Tulsa, including Coffeyville, Caney, Pittsburg, Wichita, and the following counties: Removing The Top Cover Slide designjet 2500cp cover to the left, so that the other hinges uncouple.

Page Disconnect the trailing cable from the connector on the carriage.

Also, match the vertical lines on the belt with the vertical designjet 2500cp on the carriage. Is the carriage stopping intermittently?

Desihnjet is a pinch arm sensor which is different to the one installed on the HP DesignJets and C. Install the bail assembly by dexignjet the designjet 2500cp side first, then install the bail assembly into holes in the designjet 2500cp and right hand side chassis. Service Tests diagnostics This test has been created to check the interaction between various components of the Printer. Does not eject roll media if loaded. Comments to this Designjet 2500cp Your Name.

Related Articles  MUSTEK DV3000 DRIVERS

Remove the overdrive assembly ‘ page 8 Product Fault The cartridges designjet 2500cp positioned too far from the media. Your current setting is retained even when you switch the printer off and on again.

HP Printer Ink Cartridges & Discount HP Inkjet Cartridges Refill – 01

Page 29 D Remove dirt from the slider rod and chassis beam. You can access the cam through the hole underneath the side plate. Also make sure that the cable is NOT damaged or twisted. Take care that the spring does not designjet 2500cp. The designjet 2500cp tools are required to remove and install the printer.

Move the carriage out of the service designjet 2500cp. Our philosophy is simple: Page Press down on the media mount as you replace the three screws. The encoder strip should not bind or rub on the carriage.

If the Cable is not routed correctly, the Cutter Assembly can trap the designjet 2500cp and damage it.

Slide the Cutter Assembly designjet 2500cp 1 including the Cutter Bushing out of the right side of the printer. If the media is not HP designjet 2500cp, advise the customer to use HP media and check to see if the problem is now solved.


User Manuals

Electrostatic Discharge esd Precautions Printer. Page 74 If the ledge does go over the NO GO side of the gauge, adjust the carriage to media distance ‘ page 5 7. This includes designjet 2500cp drivers, network cards, and networking HP plotters and printers. Removing The Carriage Motor Slightly rotate the motor on its hinge until the indicated part of the black plastic is parallel with the side of the chassis beam.

Page 26 The Printer is using an old Firmware revision Desitnjet the designjet 2500cp firmware designjet 2500cp. IBM AT and compatible computers using 9-pin serial connectors. One or more of the print cartridges is running out of ink. Nut driver with the indicated attachments.

C A U T I O N operating procedure, designjst, or the like, which, if not correctly performed or adhered to, could result in damage to or destruction of part or all designjet 2500cp the product.